I’ve got an iGaging 35-series digital micrometer. At $40 shipped in two days, it’s great…
Category: Technical Articles
The fantastic STM32 Discovery boards from ST Micro all come with an embedded ST-Link/V2 debugger onboard, including some jumpers to disconnect it from the target device for use as a standalone SWD debugger. Presumably, this is to allow for easy use debugging a custom end-product PCB, but it’s also useful if you have any other STM32 evaluation boards hanging around with no built-in debugger, but don’t happen to have a proper JTAG dongle handy. Here’s how to make an adapter.
This will be effectively a copy of my previous post, but targeted at OS X. The gist is, get a toolchain, debug connector, and open-source firmware library set up to use the STM32F4DISCOVERY dev board from ST as quickly as possible on OS X. Unfortunately, it’s not QUITE as easy as on Ubuntu. Fortunately, it’s not a lot worse.
This tutorial follows the same basic outline as this post on cu.rious.org but some things have changed since that was written such that it no longer works unmodified, and the various similar tutorials leave some bits out. My goal here is to get some custom code on the STM32F4DISCOVERY board as quickly as possible, hopefully paving the way in the near future for a full eclipse-based IDE setup.
I pulled apart my car’s start/stop button today to redo some chipping paint that was bothering me. Naturally, I couldn’t stop at only the cosmetic plastic once I saw that there was a small PCB inside. There are two interesting things about this picture. First, look at the PCB: there are some electronics (and more than just regulators to drive the LED), an LED to illuminate the button, and nothing else.